Kuvagalleria
(1/12)
Teac A-2300S Stereo kelanauhuri
Myydään
420 €
Toimitus alkaen 6,90 € + ToriDiili-palvelumaksu 26,62 €
Shoppaile ToriDiilillä kuin verkkokaupassa
Toimituksen jälkeen sinulla on 24 tuntia aikaa tarkistaa tavara. Jos tavarassa on jotain vialla, saat rahasi takaisin
Luo paketti
Osta enemmän samalta myyjältä ja maksa vain yhdet toimituskulut.
Tuotteen kuvaus
Kunto: Hyvä
Tyyppi: Muut stereolaitteet
Erinomaisessa kunnossa ja täysin ehjä kelanauhuri max. 7" keloille. Japanilainen laite 100v ja muuntaja 230V mukaan.
Kelat ei ole myynnissä.
Commentary
A stereo tape deck designed to improve usability by integrating advanced mechanisms.
The head uses a high hardness permalloy head with excellent wear resistance.
The head has a front shield to prevent crosstalk from adjacent tracks and the influence of leakage flux of the transformer motor, and the separation is improved.
Ferrite core is used for the erasing head and litz wire is used for the winding.
In addition, the push-pull type oscillation circuit with a margin provides stable operation even for deep-biased low-noise tapes.
The 3-head system, with separate recording and playback heads, allows simultaneous monitoring of playback sound from tape. The level meter also works with the monitor switch to indicate the input level and playback level.
The equalizer stage of the pre-amplifier uses a 3-stage direct connection circuit that combines NPN-PNP-NPN transistors.
This circuit method is also applied to the line amplifier (two stage) to obtain a stable dynamic range from high to low frequencies.
All operation mechanisms use micro switches to improve operability.
In addition, quick cutting is possible with the pose mechanism of quick operation.
It is possible to follow up recording. During playback, press the Play button again while pressing the Rec button to start recording.
Equipped with timer recording / playback mechanism, timer recording and playback is possible by combining timer control adapter sold separately with timer.
The microphone input and line input volumes are independent, making it possible to record mixed sound.
The bias and equalizer can be switched independently, making it possible to bring out the performance of the tape.
It uses an expanded scale level meter that is independent on the left and right.
It uses a quick lock reel clamper and can be set just by turning the shaft to the right.
Also, the height can be adjusted by turning the screw attached to the reel stand with a Phillips screwdriver.
The panel chassis is a combination of stainless steel and aluminum, and the side is a die-cast reinforced frame.
To protect the tape, the brake mechanism is made of aluminum die-cast and special felt, enabling stable braking.
There was a remote controller sold separately.
Model Rating
Type Tape deck
Track format 4-track, 2-channel stereo system
Heads 3-Head : Record, Play, Erase
Reel Type 17 (No. 7), Type 12 (No. 5)
Tape speed 19 cm, 9.5 cm (± 0.5%)
Motor For Capstan : 2 Speed Hysteresis Synchronous Motor x1
For Reel : 2 Eddy Current Induction Motors
Wow flutter 19cm:0.08%(WRMS)
9.5cm:0.10%(WRMS)
Frequency characteristic 19 cm : 30 Hz to 28 kHz (40 Hz to 24 kHz ± 3 dB)
9.5 cm : 30 Hz to 20 kHz (40 Hz to 16 kHz ± 3 dB)
Signal-to-noise ratio 55dB
Distortion factor 1% (Reference Level)
Crosstalk 60dB(1kHz)
Stereo separation 50dB(1kHz)
Early winding time 140 seconds (550m tape)
Input Microphone : 0.25mV/600 Ω ~ 10k Ω Compatible (-72dB)
Line : 0.1 V / input impedance 100k Ω
Output Line : 0.3 V / Input impedance 10k Ω or more
Headphone : 8 Ω
Pwer 100V AC 50Hz/60Hz
Power consumption 95W
External dimensions Width 440x Height 392x Depth 210 mm
Weight 18kg
Käyttäjäprofiili
Kirjaudu sisään, jos haluat nähdä profiilin ja lähettää viestejä.
Ilmoituksen metatiedot
Viimeksi muokattu: 17.10.2026 klo 11.33 ・ Ilmoituksen tunnus: 48625083
